The LG Hombot/VParquet vacuum cleaner does NOT have network-capabilities by default. However, since it has a USB port, you can upgrade the firmware, load custom firmware and equip it with a Wifi dongle. How to do this is explained here: - Dutch: http://www.domotica.center/robotstofzuiger-lg-hombot-vparquet/ - German: http://www.roboter-forum.com/showthread.php?10009-LG-Hombot-3-0-(VR6260-VR6270-VR6340)-WLAN-Steuerung-per-Weboberfl%E4che - English: http://www.roboter-forum.com/showthread.php?10009-LG-Hombot-3-0-%28VR6260-VR6270-VR6340%29-WLAN-Steuerung-per-Weboberfl%E4che&p=107354&viewfull=1#post107354
If you don’t do this, you cannot control the vacuum cleaner with Homey using this app.
WANT TO SHOW YOUR APPRECIATION FOR THIS APP? A DONATION IS POSSIBLE VIA HTTP://WWW.D2C.NL
You need to have the (local) IP-address of your receiver to add the device to Homey (There is no discovery (yet)).
The following cards will be enabled in the flow: - [ACTION] Start cleaning - [ACTION] Pause cleaning - [ACTION] Return to loadingstation. - [ACTION] Set clean mode (zigzag, spiral spot, cell by cell) - [ACTION] Set turbo on/off - [ACTION] Set repeat on/off - [ACTION] Move forward - [ACTION] Move backward - [ACTION] Turn left - [ACTION] Turn right
- [CONDITION] Is (not) cleaning
- [CONDITION] Is (not) reachable
- [CONDITION] Is (not) heading to docking station
- [CONDITION] Is (not) docking
- [CONDITION] Is (not) charging
Use at your own risk, I accept no responsibility for any damages caused by using this app.
VERSION 0.9.6: - Bugfix for version 0.9.1
VERSION 0.9.5: - Added ability to change IP of your Hombot device - SADLY, THIS MEANS YOU WILL HAVE TO REMOVE YOUR DEVICE AND ADD IT AGAIN
VERSION 0.9.4: - Conditions are now available - New commands for moving Hombot around, cleaning modes, turbo and repeat.
VERSION 0.9.3: - Added new commands
VERSION 0.9.0: - First release