EV Charger
Angeschaltet
Victron Energy
Blue Power
Instantly monitor the battery state of charge, power consumption, power harvest from PV, and mains. Create a flow to get notified if there is an alarm or a warning.
Build control flows to disable or limit the power of the inverter if a car is charging. Easily control the switch position (mode) of your system; Charger Only, Inverter Only, On or Off. All Victron Energy Storage Systems (ESS) standard actions are supported.
Unterstützte Geräte
Flow-Karten
Klicke oben auf ein Gerät, um nur verwandte Flow-Karten anzuzeigen.
Wenn ...
EV Charger
Ausgeschaltet
EV Charger
Der Verbrauch hat sich gändert
EV Charger
Der elektrische Strom hat sich geändert
EV Charger
Der Gesamtverbrauch hat sich geändert
EV Charger
Status changed to [[status]]
Tank sensor
Status changed to [[status]]
Tank sensor
Tank level changed to [[level]]
Temperature sensor
Die Temperatur hat sich geändert
Temperature sensor
Die Luftfeuchtigkeit hat sich geändert
Temperature sensor
Der Druck hat sich geändert
Temperature sensor
Die Spannung hat sich geändert
Temperature sensor
Status changed to [[status]]
Victron GX
Der Batteriestand hat sich geändert
Victron GX
Der Verbrauch hat sich gändert
Victron GX
Der Gesamtverbrauch hat sich geändert
Victron GX
Alarm status changed to [[status]] with [[alarms]] and [[warnings]]
Victron GX
Battery status changed to [[status]]
Victron GX
Battery voltage changed to [[voltage]]
Victron GX
Grid surplus changed to [[power]] / [[single_phase]] / [[three_phase]]
Victron GX
Input source changed to [[source]]
Victron GX
Switch position changed
Victron GX
VE Bus status changed to [[status]]
Und ...
EV Charger
Ist an
Victron GX
AC inputs are below Power (W)
Victron GX
AC loads are below Power (W)
Victron GX
AC outputs are below Power (W)
Victron GX
Battery power is below Power (W)
Victron GX
Battery status is Status
Victron GX
Max charge current is Condition Current (A)
Victron GX
Consumption power is below Power (W)
Victron GX
Excess solar power is below Power (W)
Victron GX
Max grid feed-in power is Condition Power (W)
Victron GX
Grid power is below Power (W)
Victron GX
Grid setpoint is Condition Power (W)
Victron GX
Input source is Source
Victron GX
Max discharge power is Condition Power (W)
Victron GX
Min SoC is Condition SoC (%)
Victron GX
Scheduled charging is enabled for schedule Schedule
Victron GX
Solar power is below Power (W)
Victron GX
Switch position is Mode
Victron GX
Time since last full charge is less than Time (seconds)
Victron GX
VE Bus status is Status
Dann ...
EV Charger
Einschalten
EV Charger
Ausschalten
EV Charger
Ein- oder ausschalten
EV Charger
Set EV charger max current to Current (A)
Used for chargers in manual mode. Sets the maximum charge current
EV Charger
Set EV charger mode to Mode
Victron GX
Create charging schedule Schedule for Day at Start time with duration Duration or SoC SoC
Creates a charging schedule. Please note you need to enter your GX device's root password in the device settings.
Victron GX
Disable charging schedule Schedule
Disables a charging schedule. Please note you need to enter your GX device's root password in the device settings.
Victron GX
Enable charging schedule Schedule
Enables a charging schedule. Please note you need to enter your GX device's root password in the device settings.
Victron GX
Limit charge current to Current (A)
Sets the maximum charge current (defined under the DVCC section).
Victron GX
Limit grid feed-in power to Power (W)
Victron GX
Limit discharge power to Power (W)
Sets the maximum inverter power (defined under ESS).
Victron GX
Set batteryLife state to Mode
Victron GX
Set multiphase regulation state to Mode
Victron GX
Switch relay 1 to State
Victron GX
Switch relay 2 to State
Victron GX
Set switch position to Mode
Victron GX
Update grid setpoint to Power (W)
Sets the grid setpoint (defined under ESS).
Victron GX
Update minimum SoC to SoC (%)
Sets the minimum SoC, unless grid fails (defined under ESS).
Support
Hast du Probleme mit dieser App? Kontaktiere den Entwickler hier.
Was ist neu?
Version 1.3.1 — New device for the EV Chargers. New icons for the different device types.
Victron Energy
Victron Energy ist mit dem gewählten Homey nicht kompatibel.
Victron Energy wird in Kürze auf Homey installiert.
Changelog
Wir werden Richard Barkestam ein Dankeschön schicken!
Wir lassen Richard Barkestam wissen, dass du die App magst. Vielleicht erwägst du, Richard Barkestam durch eine Spende zu unterstützen?
Spende an Richard Barkestam
Der Entwickler von Victron Energy akzeptiert Spenden.
Spende etwas, um Danke zu sagen!
Dein Vorschlag wurde gesendet
Wir werden Richard Barkestam benachrichtigen, dass du einen Vorschlag gesendet hast.
