Homey app to receive data from your Exvent eWind/eAir ventilation systems via Modbus TCP.
The modbus app receives data about every 60 seconds.
Remember to activate Modbus TCP in the eWind app before trying to connect and to give it a static IP in your router.
Supported devices
Following devices are supported
- Exvent eWind systems
- Exvent eAir systems
NOT SUPPORTED: The new iSLa app from Exvent. Modbus is not working on that app/firmware.
Lees meer ›
Flow kaarten
Klik op een apparaat hierboven om gerelateerde Flow kaarten te zien.
Als...
eAir
Filter alarm triggered
eAir
Heat exchanger mode changed to ...
eAir
Heater mode changed to ...
eWind
Filter alarm triggered
eWind
Mode changed to ...
eWind
Heat exchanger changed to ...
eWind
Heater changed to ...
En...
eAir
eAir status mode is ...
eAir
Heat exchanger mode is ...
eWind
eWind status mode is ...
eWind
Heat exchanger mode is ...
eWind
Heating element is ...
Dan...
eAir
Set heatingcoil to ...
eAir
Set temperature to ...
eWind
Set heatingcoil to ...
eWind
Set temperature to ...
Ondersteuning
Heb je een probleem met deze app?
Neem contact op met de ontwikkelaar per e-mail.
Wat is nieuw
Versie 3.1.2 — Bugfix: Flowcard for setting mode on eAir had a typo that preventet it from running.
Bekijk changelog