eAir
The filter alarm went off
Exvent
Fresh air, on autopilot.
Exvent eWind and eAir ventilation units connect over Modbus TCP and show up as a single device with live temperatures, humidity, heat recovery efficiency, fan speed and filter status. Home, Away, Fireplace, Enhanced ventilation, Boost and Off can be switched by hand or from a Flow, along with target temperature, eco mode and the heating coil.
Before adding the unit, enable Modbus TCP from the eWind or eAir panel and give the unit a fixed IP address in your router. You then only need that IP address and the port, which is 502 on a standard installation.
Dispositivos compatibles
Tarjetas Flow
Haz clic en el dispositivo de arriba para mostrar solo las tarjetas Flow relacionadas.
Cuando...
The unit reports that the filter needs replacing.
eAir
Mode changed to ...
eAir
Heat exchanger changed to ...
eAir
Heating coil changed to ...
eWind
The filter alarm went off
The unit reports that the filter needs replacing.
eWind
Mode changed to ...
eWind
Heat exchanger changed to ...
eWind
Heating coil changed to ...
Y...
eAir
Mode is ...
eAir
Heat exchanger is ...
eAir
Heating coil is ...
eWind
Mode is ...
eWind
Heat exchanger is ...
eWind
Heating coil is ...
Entonces...
eAir
Set eco mode to ...
eAir
Set heating coil to ...
Allows or blocks the unit from using its heating coil.
eAir
Set target temperature to ...
eAir
Set mode to ...
eAir
Reset filter change reminder
Resets the unit's filter/service day counter to 0. Use after replacing the filter.
eWind
Set eco mode to ...
eWind
Set heating coil to ...
Allows or blocks the unit from using its heating coil.
eWind
Set target temperature to ...
eWind
Set mode to ...
eWind
Reset filter change reminder
Resets the unit's filter/service day counter to 0. Use after replacing the filter.
Asistencia
¿Tienes algún problema con esta aplicación? Contacta con el desarrollador a través de un correo electrónico.
Novedades
Versión 4.10.1 — The Mode changed, Heating coil changed and Heat exchanger changed triggers still did not match in 4.10.0. Their check read a device that a device trigger card never passes along, so it failed before it could compare anything.
Exvent
Exvent no es compatible con el Homey seleccionado.
Exvent se instalará en Homey en breve.
Registro de cambios
¡Enviaremos un agradecimiento a Vegard Fladby!
Le haremos saber a Vegard Fladby que te encanta la aplicación.
Se han enviado tus sugerencias
Avisaremos a Vegard Fladby para que esté al tanto de las sugerencias.
Africa
Asia
Europe
Belgium
Deutsch English
Bulgaria
Croatia
Cyprus
Czech Republic
Estonia
Finland
Greece
Hungary
Iceland
Ireland
Latvia
Lithuania
Malta
Moldova
The Netherlands
Portugal
Romania
Slovakia
Slovenia
Türkiye
Ukraine
United Kingdom
