Remeha Heat Pump
Termostattilstand er blevet ændret ...
Remeha
Make your heat pump work smarter, not harder
Keep an eye on your Remeha heat pump and adjust it on the fly, all from Homey. See what your system is doing in real time and tweak settings whenever you need to. Use Flows to automate your comfort and save on energy costs.
Supports the Remeha Elga Ace Split, Monoblock and All-in-One models. You will need a GTW-08 gateway with an RS485-to-Ethernet adapter to get your heat pump on the network. Optionally pair it with a Homey power meter for complete energy insights.
Understøttede enheder
Flow-kort
Klik på en enhed ovenfor for kun at vise relaterede Flow-kort.
Når...
Remeha Heat Pump
Måltemperaturen blev ændret
Remeha Heat Pump
Temperaturen ændrede sig
Remeha Heat Pump
Trykkey ændrede sig
Remeha Heat Pump
Vandstrømmen har ændret sig
Remeha Heat Pump
Strømmåleren ændrede sig
Remeha Heat Pump
Strømmen ændrede sig
Remeha Heat Pump
COP dropped below Threshold
Triggers once when the calculated COP crosses below the threshold (fires on the transition, not continuously).
Remeha Heat Pump
Defrost cycle started
Triggers when the heat pump enters a defrost cycle.
Remeha Heat Pump
Defrost cycle ended
Triggers when the heat pump finishes a defrost cycle.
Remeha Heat Pump
An error was cleared
Triggers when the heat pump returns to normal operation after an error.
Remeha Heat Pump
An error occurred
Triggers when the heat pump reports an error. Use the tokens to inspect the error code and priority.
Remeha Heat Pump
Hybrid mode changed
Triggers whenever the hybrid mode changes (auto / heat pump / boiler only).
Remeha Heat Pump
Status changed to Status
Triggers when the heat pump status transitions to the selected state.
Og...
Remeha Heat Pump
Termostattilstand er ...
Remeha Heat Pump
Domestic hot water is active
Remeha Heat Pump
Heat pump has an active error
Remeha Heat Pump
Hybrid mode is Mode
Remeha Heat Pump
Heat pump is actively heating
True when the compressor is running (status is Heat pump, Hybrid, or Defrost).
Remeha Heat Pump
Heat pump is defrosting
Remeha Heat Pump
Heat pump status is Status
Så...
Remeha Heat Pump
Indstil tilstanden ...
Remeha Heat Pump
Indstil temperaturen °C
Remeha Heat Pump
Set energy to Energy in kWh kWh
Remeha Heat Pump
Set power to Power in watts W
Remeha Heat Pump
Set gas tariff to Tariff in ct/m³ ct/m³
Warning: Do not change tariffs more than 6 times per day!
Remeha Heat Pump
Set electricity off-peak tariff to Tariff in ct/kWh ct/kWh
Warning: Do not change tariffs more than 6 times per day!
Remeha Heat Pump
Set electricity peak tariff to Tariff in ct/kWh ct/kWh
Warning: Do not change tariffs more than 6 times per day!
Support
Har du et problem med denne app? Kontakt udvikleren her.
Hvad er nyt
Version 1.1.0 — Major Flow upgrade: 7 new triggers (defrost start/stop, error occurred/cleared, status changes, hybrid-mode changes, COP drops below threshold) and 6 new conditions (is active, is defrosting, has error, status is, hybrid mode is, DHW active). 7 new status sensors decoded from the bitfields (backup heater 1/2 active, DHW backup active, service required, water pressure low, cooling active, solar active). Writable COP switch-threshold (HP054) added for fine-tuning hybrid mode. Hybrid-mode labels now match the official Remeha spec (No hybrid / Cost / Efficiency / CO₂). Tariff writes are rate-limited per spec (max 6 per 24h) and all writes are clamped to safe register ranges. Support URL now points to the community forum.
Remeha
Remeha er ikke kompatibel med den valgte Homey.
Remeha bliver snart installeret på Homey.
Ændringslog
Vi sender en tak til Paul Vermeulen!
Vi lader Paul Vermeulen vide, at du elsker appen.
Dit forslag er blevet sendt
Vi giver Paul Vermeulen besked, når du har sendt et forslag.
Africa
Asia
Europe
Belgium
Deutsch English
Bulgaria
Croatia
Cyprus
Czech Republic
Estonia
Finland
Greece
Hungary
Iceland
Ireland
Latvia
Lithuania
Malta
Moldova
The Netherlands
Portugal
Romania
Slovakia
Slovenia
Türkiye
Ukraine
United Kingdom
