Add a virtual thermostat to a zone with a temperature sensor and it will turn on / off heaters in the same zone. The virtual thermostat will start operating when the target temperature has been set.
Use a door/window sensor in the same zone to automatically turn off the heater on a contact alarm. This can be enabled with the 'Turn off if contact alarm' - checkbox in 'Advanced settings'.
Add a virtual humidity controller to a zone with a humidity sensor and it will turn on / off fans in the same zone.
Fans will turn on if the humidity is larger than the target humidity, and off if less than the target humidity. For humidifiers the logic can be inverted, by selecting the 'Invert for humidifier' - checkbox in 'Advanced settings'.
Læs mere
›
Doner
Flow-kort
Klik på en enhed ovenfor for kun at vise relaterede Flow-kort.
Når...
VHumidity
Luftfugtigheden ændrede sig
VHumidity
Humidity device turned off
VHumidity
Humidity device turned on
VHumidity
Target humidity changed
VThermo
Måltemperaturen blev ændret
VThermo
Temperaturen ændrede sig
VThermo
Heating turned off
VThermo
Heating turned on
Og...
VHumidity
Humidity has decreased more than Decrease in % points last Minutes
VHumidity
Humidity has increased more than Increase in % points last Minutes
VHumidity
Humidity device is active
VThermo
Thermostat is active
Så...
VHumidity
Tænd eller sluk
VHumidity
Set the target humidity to Target humidity
i
Set the target humidity.
VThermo
Indstil temperaturen °C
VThermo
Invert switch 'Invert switch'
i
Select 'Enable' and the thermostat will switch on if above the target, and switch off if below the target.
VThermo
Update temperature to Temperature °C
i
Update the temperature, e.g. from a temperature sensor in another zone.
VThermo
Update target temperature min to Target temperature minimum, max to Target temperature maximum and step to Target temperature step (°C)
i
Update minimum, maximum and step for target temperature.
VThermo
Update target temperature offset to Target temperature offset
i
Update the offset when target temperature is updated from a master VThermo - thermostat.
VThermo
Target temperature update enabled or disabled target temperature update
i
Enable or disable being updated from a master VThermo - thermostat.
Anmeldelser
Denne app har endnu ingen anmeldelser.
Du kan skrive en anmeldelse, når du bruger denne app.

Tak for din anmeldelse.
Indsend anmeldelse
Skriv en anmeldelse
Hvad er nyt
Version 1.9.2 — Avoid black screen in mobile app for 'Heating turned off' trigger.
Se ændringslog