Octoprint
Tændt
Octoprint
Control and monitor your 3D printer
OctoPrint is a web interface for your 3D printer.
Supported Languages:
English
Dutch
Norwegian
Features:
- Connect/disconnect
- Set/Get tool temperatures
- Set/Get bed temperatures
- Set/Get chamber temperatures
- Get states
- Get sensors
- Get times
- Get camera (snapshot)
Understøttede enheder
Flow-kort
Klik på en enhed ovenfor for kun at vise relaterede Flow-kort.
Når...
Octoprint
Slukket
Octoprint
Print started
When a print starts
Octoprint
Print finished
When a print is finished
Octoprint
Print paused
When a print is paused
Octoprint
Print resumed
When a print has resumed after being paused
Octoprint
Print stopped
When a print has stopped
Octoprint
Completion percentage changed
The calculated values are based on the print time with the time left, this can be more accurate.
Octoprint
Bed target temperature changed
Octoprint
Tool target temperature changed
Octoprint
Chamber target temperature changed
Octoprint
Current bed temperature changed
Octoprint
Current tool temperature changed
Octoprint
Current chamber temperature changed
Octoprint
Bed is cooled down
Octoprint
Tool is cooled down
This will always trigger when the temperature reaches below the specified threshold, for example also when the printer is waiting for a filament change (filament runout).
Octoprint
Octoprint state changed
Octoprint
Estimated time changed
Octoprint
Estimated end time changed
Octoprint
Time left changed
Octoprint
Print time changed
Octoprint
Print file changed
Octoprint
An error occurred
Og...
Octoprint
Er tændt
Octoprint
Is printing
Octoprint
Bed is cooled down
Octoprint
Tool is cooled down
Octoprint
State of octoprint is State
Så...
Octoprint
Tændt
Octoprint
Slukket
Octoprint
Tænd eller sluk
Octoprint
Set the bed temperature to Temperature
Octoprint
Set the tool temperature to Temperature
Octoprint
Set the chamber temperature to Temperature
Octoprint
Cancel current print
Octoprint
Home axis: G28 Axis/custom
Home any or all axis (G28), if you don't fill in a axis it will home all 3 axis
Octoprint
Move Axis to Position with a speed of Speed
Move axis to a set position (G1), speed is optional (default: 3000)
Octoprint
Send G-Code: G-Code
Send any G-Code to the printer.
Do be careful!
You can send multiple G-Codes by seperating them with a semicolon ( ; ).
Octoprint
Display a message: Message
Display a message in the printer's display (M117)
Octoprint
Emergency stop (M112)
Octoprint
Reboot Raspberry Pi
Octoprint
Shutdown Raspberry Pi
Support
Har du et problem med denne app? Kontakt udvikleren her.
Hvad er nyt
Version 1.1.10 — Validate "completion" token for print_stopped trigge
Octoprint
Octoprint er ikke kompatibel med den valgte Homey.
Octoprint bliver snart installeret på Homey.
Ændringslog
Vi sender en tak til Bretislav Kubesa!
Vi lader Bretislav Kubesa vide, at du elsker appen. Overvej måske at støtte Bretislav Kubesa ved at give en donation?
Donér til Bretislav Kubesa
Udvikleren af Octoprint tager imod donationer.
Giv et bidrag for at sige tak!
Dit forslag er blevet sendt
Vi giver Bretislav Kubesa besked, når du har sendt et forslag.
