Dish
Zmiana mocy
Starlink Monitor
Keep an eye on the sky above your dish.
Reads your Starlink dish on your local network for throughput, latency, packet loss, obstruction, visible satellites and power draw, with no account, key or cloud call. It also shows where the dish points against where it would like to, and the cause and duration of each recent outage.
Obsługiwane urządzenia
Karty Flow
Kliknij na urządzenie powyżej, aby wyświetlić tylko powiązane karty Flow.
Kiedy...
Dish
The alignment error rises above °°
The angle between where the dish points and where it would like to point. A large gap means the dish should be moved.
Dish
The latency rises above ms ms
Dish
Sky obstruction rises above % %
The share of the sky hidden by trees, roofs or masts, as the dish measured it over time.
Dish
The download speed drops below Mb/s Mb/s
Measured traffic, not a speed test: it falls to nearly zero when nobody is using the line.
Dish
The dish state changes
Booting, stowed, obstructed, searching the sky, thermal shutdown, and so on.
Dish
An outage started
Seen by the dish status at a reading. An outage shorter than the refresh interval may only be reported when it ends.
Dish
An outage of at least s s ended
Taken from the dish's own outage log, so even very short outages are seen. Use the minimum duration to ignore them.
Dish
The 24 h availability drops below % %
Share of the last 24 hours without an outage, out of the time the app could observe.
Dish
The dish raised an alert
Thermal throttling, stuck motors, mast not vertical, slow Ethernet, pending update, and the other alerts the dish reports.
Dish
A dish alert cleared
Dish
Packet loss rises above % %
Dish
The dish stops responding
After three readings without an answer, about three minutes with the default interval.
Dish
The dish responds again
Dish
The dish has restarted
Dish
The dish software has been updated
Dish
The Ethernet link speed changes
The speed is 0 when the link is down.
Dish
The dish starts moving
The dish reports that it is travelling fast, in a vehicle or on a boat.
Dish
The dish stops moving
Oraz...
Dish
The dish is ready
All of the dish's start-up steps have completed.
Dish
The dish is misaligned
Compared with the threshold set in the device settings.
Dish
The alignment error is above °°
Dish
The alert ... is active
Dish
The dish responds
Based on the last reading.
Dish
The sky is obstructed right now
Wtedy...
Dish
Refresh now
Reads the dish right away instead of waiting for the next reading.
Widżety
Pomoc
Masz problem z tą aplikacją? Skontaktuj się z twórcami aplikacji, wysyłając mejla.
Nowości
Wersja 1.2.0 — Every indicator now has its own icon, and the device icon shows the dish on its tripod. New Flow cards warn when packet loss rises above a threshold, when the dish stops responding or responds again, restarts, gets new software, changes Ethernet speed, starts or stops moving; two conditions tell whether the dish responds and whether the sky is obstructed right now, and an action refreshes the readings on demand.
Starlink Monitor
Starlink Monitor nie jest kompatybilna z wybranym Homey.
Starlink Monitor zostanie wkrótce zainstalowana na Homey.
Lista zmian
Wyślemy podziękowanie do Henri Dominique Rapin!
Poinformujemy Henri Dominique Rapin, że uwielbiasz tę aplikację.
Twoja sugestia została wysłana
Powiadomimy Henri Dominique Rapin o otrzymaniu sugestii.
Africa
Asia
Europe
Belgium
Deutsch English
Bulgaria
Croatia
Cyprus
Czech Republic
Estonia
Finland
Greece
Hungary
Iceland
Ireland
Latvia
Lithuania
Malta
Moldova
The Netherlands
Portugal
Romania
Slovakia
Slovenia
Türkiye
Ukraine
United Kingdom
