eAir
Filter alarm triggered
Exvent
Improve your indoor climate with your ventilation system
Homey app to receive data from your Exvent eWind/eAir ventilation systems via Modbus TCP.
The modbus app receives data about every 60 seconds.
Remember to activate Modbus TCP in the eWind app before trying to connect and to give it a static IP in your router.
Supported devices
Following devices are supported
- Exvent eWind systems
- Exvent eAir systems
NOT SUPPORTED: The new iSLa app from Exvent. Modbus is not working on that app/firmware.
Enheter som stöds
Flow-kort
Klicka på en enhet ovan för att visa endast relaterade Flow-kort.
När...
Filter needs replacement
eAir
Mode changed to ...
Ventilation changed to
eAir
Heat exchanger mode changed to ...
Heat exchanger mode was changed
eAir
Heater mode changed to ...
Heater mode was changed
eWind
Filter alarm triggered
Filter needs replacement
eWind
Mode changed to ...
Ventilation changed mode
eWind
Heat exchanger changed to ...
Heat exchanger mode was changed
eWind
Heater changed to ...
Heater mode was changed
Och...
eAir
eAir status mode is ...
eAir
Heat exchanger mode is ...
eAir
Heater mode is ...
eWind
eWind status mode is ...
eWind
Heat exchanger mode is ...
eWind
Heating element is ...
Då...
eAir
Set ecomode to ...
Set ecomode to
eAir
Set heatingcoil to ...
Set heatingcoil to
eAir
Set temperature to ...
Set target temperature
eAir
Set mode to ...
Set mode to
eWind
Set ecomode to ...
Set ecomode to
eWind
Set heatingcoil to ...
Set heatingcoil to
eWind
Set temperature to ...
Set target temperature
eWind
Set mode to ...
Set mode to
Support
Har du problem med den här appen? Kontakta utvecklaren genom att skicka ett e-postmeddelande.
Vad är nytt?
Version 3.1.0 — Added the possibility to control the heating coil on or off.
Ändringslogg
Vi kommer att skicka en tacksamhet till Vegard Fladby!
Vi låter Vegard Fladby veta att du älskar appen.
Ditt förslag har skickats
Vi skickar ett meddelande till Vegard Fladby om att du har skickat ett förslag.
