Add support for Heliotherm Heat Pump
Control:
- Set the Domestic Hot Water (DHW) temperature.
- Increase / decrease setpoint for heating.
Shows the following sensor data:
- Domestic Hot Water (DHW) temperature
- Buffer temperature
- Outdoor temperature
- Current request: none|cool|heat|dhw
- SmartGrid mode: Disabled | Block | Allow
- SCOP for Heating
- SCOP for DHW
- Total weighted SCOP
SCOP calculations:
The SCOP (Seasonal COP) is calculated based on the amount of electrical energy used
and heat energy generated.
The total SCOP is a weighted average of Heating SCOP and DHW SCOP
based on the amount of hours run for each.
Device settings:
- Enabled / Disable smart grid
- Modbus Port / ID
- Default Setpoint for heating in celcius.
Allow / Block action flow cards:
Only when smart grid is enabled in the device settings,
the heatpump can be given the command to block all heatpump requests
or allow heatpump requests using flow card.
This can for example be used to only run the heatpump when electricity prices are low.
Installation:
To use this application you need to enable modbus TCP on your Heliotherm heatpump. See Enabling Modbus TCP for Heliotherm heat pumps with RCG2 instruction guide how to do this.
You can find a link to the PDF guide in the Homey Community Forum topic of this app.
Les mer ›
Flow-kort
Klikk på en enhet ovenfor for å kun vise relaterte Flow-kort.
Når …
Heatpump
Heatpump Started
Heatpump
Heatpump Stopped
Og …
Heatpump
Heatpump is running
Så …
Støtte
Har du et problem med denne appen?
Kontakt utvikleren her.
Nyheter
Versjon 1.3.3 — Fixed conflict with system capability. Added extra error handling when device is not available anymore.
Vis endringslogg