V2C Wallbox
Car is connected
V2C Wallbox
Intelligence, innovation and maximum control at your fingertips
The app allows you to monitor your V2C Wallbox online, retrieve complete data on charging progress, vehicle connection, and more, and control other devices in your home through flows based on this data.
Latest release added a THEN controls for your wallbox. Some of them should be used only with dynamic mode on (min, max intensity) and some of them without dynamic mode (intensity).
App is based on HTTP GET specification and controls wallbox via local network. So Homey and V2C wallbox should be on same network.
Tested on V2C Trydan charger, but should work for every V2C charger.
Ondersteunde apparaten
Flow kaarten
Klik op een apparaat hierboven om gerelateerde Flow kaarten te zien.
Als...
V2C Wallbox
Car is disconnected
V2C Wallbox
Car starts charging
V2C Wallbox
Slave Error Changed
En...
V2C Wallbox
Car is connected
V2C Wallbox
Car is charging
V2C Wallbox
Power is greater than Power (W) W
V2C Wallbox
Power is less than Power (W) W
V2C Wallbox
Charging is paused
V2C Wallbox
Charging is not paused
Dan...
V2C Wallbox
Set Charger State to Pause
V2C Wallbox
Set Lock State to Lock
V2C Wallbox
Set Charger Intensity to Intensity Amps
V2C Wallbox
Set charging power to Power W (Phase Mode phase, Voltage V, Voltage Type and max intensity Maximum Amps Amps)
Enter power in Watts. Both positive and negative values are accepted and will be converted to positive for calculation. The resulting Ampere values are rounded mathematically and limited to a minimum of 6 Amps and a maximum defined by the specified value. If the wallbox has a neutral cable connected, select the Line-to-Neutral wiring type. For single-phase charging, either wiring type can be selected. However, make sure to also set the single-phase output directly in the wallbox menu.
Advanced
V2C Wallbox
Set Dynamic Mode to Dynamic Mode
V2C Wallbox
Set Minimum Intensity in Dynamic Mode to Minimum Intensity Amps
V2C Wallbox
Set Maximum Intensity in Dynamic Mode to Maximum Intensity Amps
V2C Wallbox
Set Dynamic Power Mode to Dynamic Power Mode
Widgets
Ondersteuning
Heb je een probleem met deze app? Neem contact op met de ontwikkelaar per e-mail.
Wat is nieuw
Versie 1.2.8 — small change to widget
V2C Wallbox
V2C Wallbox is niet compatibel met de geselecteerde Homey
V2C Wallbox wordt op Homey geïnstalleerd.
Changelog
We sturen een bedankje naar Jiri Pech!
We laten Jiri Pech weten dat je dol bent op de app. Overweeg om Jiri Pech te ondersteunen door een donatie te maken?
Doneer aan Jiri Pech
De ontwikkelaar van V2C Wallbox accepteert donaties.
Support de ontwikkelaar en doe een donatie!
Je voorstel is verzonden
We laten Jiri Pech weten dat je een voorstel hebt verzonden.
