Battery
El nivel de la batería ha cambiado
Victron Energy
Blue Power
¡Advertencia! Es posible que esta aplicación no funcione correctamente.
Esta aplicación se está probando y nunca se ha revisado. Puede que no funcione como se espera.
Ten mucho cuidado al instalar esta aplicación.
Instantly monitor the battery state of charge, power consumption, power harvest from PV, and mains. Create a flow to get notified if there is an alarm or a warning.
Build control flows to disable or limit the power of the inverter if a car is charging. Easily control the switch position (mode) of your system; Charger Only, Inverter Only, On or Off. All Victron Energy Storage Systems (ESS) standard actions are supported.
Dispositivos compatibles
Tarjetas Flow
Haz clic en el dispositivo de arriba para mostrar solo las tarjetas Flow relacionadas.
Cuando...
Battery
El estado de carga de la batería ha cambiado ...
Battery
La alarma general se ha activado
Battery
La alarma general se ha desactivado
Battery
La potencia ha cambiado
Battery
La tensión ha cambiado
Battery
La corriente eléctrica ha cambiado
Battery
La temperatura ha cambiado
Energy Meter
La potencia ha cambiado
Energy Meter
El contador de energía ha cambiado
Energy Meter
Grid surplus changed to [[power]] / [[single_phase]] / [[three_phase]]
EV Charger
Encendido
EV Charger
Apagado
EV Charger
La potencia ha cambiado
EV Charger
La corriente eléctrica ha cambiado
EV Charger
El contador de energía ha cambiado
EV Charger
Status changed to [[status]]
PV Inverter
La potencia ha cambiado
Solar Charger
La potencia ha cambiado
Solar Charger
La corriente eléctrica ha cambiado
Solar Charger
La tensión ha cambiado
Solar Charger
El contador de energía ha cambiado
Tank sensor
Status changed to [[status]]
Tank sensor
Tank level changed to [[level]]
Temperature sensor
La temperatura ha cambiado
Temperature sensor
La humedad ha cambiado
Temperature sensor
La presión ha cambiado
Temperature sensor
La tensión ha cambiado
Temperature sensor
Status changed to [[status]]
Victron GX
La potencia ha cambiado
Victron GX
Alarm status changed to [[status]] with [[alarms]] and [[warnings]]
Victron GX
Dynamic ESS mode changed to Mode
Victron GX
Input source changed to [[source]]
Victron GX
Switch position changed
Victron GX
VE Bus status changed to [[status]]
Y...
Battery
El estado de carga de la batería es ...
Battery
La alarma general está activada
Battery
Time since last full charge is less than Time (seconds)
EV Charger
Está encendido
Victron GX
AC inputs are below Power (W)
Victron GX
AC loads are below Power (W)
Victron GX
AC outputs are below Power (W)
Victron GX
Max charge current is Condition Current (A)
Victron GX
Consumption power is below Power (W)
Victron GX
Excess solar power is below Power (W)
Victron GX
Max grid feed-in power is Condition Power (W)
Victron GX
Grid power is below Power (W)
Victron GX
Grid setpoint is Condition Power (W)
Victron GX
Input source is Source
Victron GX
Max discharge power is Condition Power (W)
Victron GX
Min SoC is Condition SoC (%)
Victron GX
Scheduled charging is enabled for schedule Schedule
Victron GX
Solar power is below Power (W)
Victron GX
Switch position is Mode
Victron GX
VE Bus status is Status
Entonces...
EV Charger
Encender
EV Charger
Apagar
EV Charger
Encender o apagar
EV Charger
Set EV charger max current to Current (A)
Used for chargers in manual mode. Sets the maximum charge current
EV Charger
Set EV charger mode to Mode
Victron GX
Create charging schedule Schedule for Day at Start time with duration Duration or SoC SoC
Creates a charging schedule. Please note you need to enter your GX device's root password in the device settings.
Victron GX
Disable charging schedule Schedule
Disables a charging schedule. Please note you need to enter your GX device's root password in the device settings.
Victron GX
Enable charging schedule Schedule
Enables a charging schedule. Please note you need to enter your GX device's root password in the device settings.
Victron GX
Limit charge current to Current (A)
Sets the maximum charge current (defined under the DVCC section).
Victron GX
Limit grid feed-in power to Power (W)
Victron GX
Limit AC import to Current (A) when peakshaving
Passing value -1 will disable the limit
Victron GX
Limit discharge power to Power (W)
Sets the maximum inverter power (defined under ESS).
Victron GX
Set batteryLife state to Mode
Victron GX
Set dynamic ESS mode to Mode
Victron GX
Set multiphase regulation state to Mode
Victron GX
Switch relay 1 to State
Victron GX
Switch relay 2 to State
Victron GX
Set switch position to Mode
Victron GX
Update grid setpoint to Power (W)
Sets the grid setpoint (defined under ESS).
Victron GX
Update minimum SoC to SoC (%)
Sets the minimum SoC, unless grid fails (defined under ESS).
Asistencia
¿Tienes algún problema con esta aplicación? Contacta con el desarrollador aquí.
Novedades
Versión 1.4.1 — New action for setting the dynamic ESS mode
Victron Energy
Victron Energy no es compatible con el Homey seleccionado.
Victron Energy se instalará en Homey en breve.
Registro de cambios
¡Enviaremos un agradecimiento a Richard Barkestam!
Le haremos saber a Richard Barkestam que te encanta la aplicación. Quizás consideres apoyar a Richard Barkestam haciendo una donación.
Donar a Richard Barkestam
El desarrollador de Victron Energy acepta donaciones.
¡Haz una donación para dar las gracias!
Se han enviado tus sugerencias
Avisaremos a Richard Barkestam para que esté al tanto de las sugerencias.
