V2C Wallbox
Car is connected
V2C Wallbox
Intelligence, innovation and maximum control at your fingertips
The app allows you to monitor your V2C Wallbox online, retrieve complete data on charging progress, vehicle connection, and more, and control other devices in your home through flows based on this data.
Latest release added a THEN controls for your wallbox. Some of them should be used only with dynamic mode on (min, max intensity) and some of them without dynamic mode (intensity).
App is based on HTTP GET specification and controls wallbox via local network. So Homey and V2C wallbox should be on same network.
Tested on V2C Trydan charger, but should work for every V2C charger.
Unterstützte Geräte
Flow-Karten
Klicke oben auf ein Gerät, um nur verwandte Flow-Karten anzuzeigen.
Wenn ...
V2C Wallbox
Car is disconnected
V2C Wallbox
Car starts charging
V2C Wallbox
Slave Error Changed
Und ...
V2C Wallbox
Car is connected
V2C Wallbox
Car is charging
V2C Wallbox
Power is greater than Power (W) W
V2C Wallbox
Power is less than Power (W) W
V2C Wallbox
Charging is paused
V2C Wallbox
Charging is not paused
Dann ...
V2C Wallbox
Set Charger State to Pause
V2C Wallbox
Set Lock State to Lock
V2C Wallbox
Set Charger Intensity to Intensity Amps
V2C Wallbox
Set charging power to Power W (Phase Mode phase, Voltage V, Voltage Type and max intensity Maximum Amps Amps)
Enter power in Watts. Both positive and negative values are accepted and will be converted to positive for calculation. The resulting Ampere values are rounded mathematically and limited to a minimum of 6 Amps and a maximum defined by the specified value. If the wallbox has a neutral cable connected, select the Line-to-Neutral wiring type. For single-phase charging, either wiring type can be selected. However, make sure to also set the single-phase output directly in the wallbox menu.
Advanced
V2C Wallbox
Set Dynamic Mode to Dynamic Mode
V2C Wallbox
Set Minimum Intensity in Dynamic Mode to Minimum Intensity Amps
V2C Wallbox
Set Maximum Intensity in Dynamic Mode to Maximum Intensity Amps
V2C Wallbox
Set Dynamic Power Mode to Dynamic Power Mode
Widgets
Support
Hast du Probleme mit dieser App? Den Entwickler kontaktieren durch Senden einer E-Mail.
Was ist neu?
Version 1.2.8 — small change to widget
V2C Wallbox
V2C Wallbox ist mit dem gewählten Homey nicht kompatibel.
V2C Wallbox wird in Kürze auf Homey installiert.
Changelog
Wir werden Jiri Pech ein Dankeschön schicken!
Wir lassen Jiri Pech wissen, dass du die App magst. Vielleicht erwägst du, Jiri Pech durch eine Spende zu unterstützen?
Spende an Jiri Pech
Der Entwickler von V2C Wallbox akzeptiert Spenden.
Spende etwas, um Danke zu sagen!
Dein Vorschlag wurde gesendet
Wir werden Jiri Pech benachrichtigen, dass du einen Vorschlag gesendet hast.
